Homebrew

Ham Radio homebrew and home-made, build your own antenna, radio

Home : Technical Reference : Homebrew : Page 4

  • Small AM Transmitter - A quick and dirty 1MHz transmitter to send old music into old radios
    [ Hits: 362 | Votes: 0 | Rating: 0.00 ]
  • SMD Jig - Prototype - Building a SMD jig to hold parts during assembly
    [ Hits: 307 | Votes: 0 | Rating: 0.00 ]
  • Soldering guide - Guide to soldering an desoldering
    [ Hits: 735 | Votes: 3 | Rating: 9.33 ]
  • Some good ideas for a big Delta Loop antenna - A 3 element DELTA LOOP on 20 meter, 4 on 15 and 5 on 10: my new beam (Just some good ideas)
    [ Hits: 7502 | Votes: 1 | Rating: 10.00 ]
  • SP5GJN - HF Power Amplifiers  pop - HF home meade power amplifiers by SP5GJN
    [ Hits: 25453 | Votes: 27 | Rating: 6.37 ]
  • Strange CW keys - Very strange morse keyers, like Onion chopper CW key, Handshake CW key, Chopsticks CW key, Typewriter CW keyboard, Refrigerator CW key by OH6DC
    [ Hits: 2076 | Votes: 4 | Rating: 10.00 ]
  • SuperVozelj Packet PC - Packet radio node computer
    [ Hits: 1032 | Votes: 1 | Rating: 1.00 ]
  • SV1BSX Homebrew Corner - Offer a wide range of homebrewing projects mainly for VHF UHF operations. From vhf antennas to preamplifiers, chargers and power supplies
    [ Hits: 1329 | Votes: 8 | Rating: 10.00 ]
  • Tenna Dipper Kit - The "Tenna Dipper" is a low power antenna analyzer and ATU tuning aid. With this handy accessory, you can determine the 50 Ohm resonance frequency of antennas or you can adjust your antenna tuner for a 50 Ohm match without generating QRM
    [ Hits: 3812 | Votes: 3 | Rating: 4.00 ]
  • The "Woodpecker" Tuning aid - This little gadget is that it allows you to tune up at full peak output power, whilst limiting the average power to a fraction of the peak, thereby protecting the PA from meltdown
    [ Hits: 3789 | Votes: 2 | Rating: 7.50 ]
  • The Egg A Plumbers PTT Switch - A PTT switch from Home Depot parts
    [ Hits: 322 | Votes: 0 | Rating: 0.00 ]
  • The G8TTI homebrews - Home made transverters blockschematics two metre HB9CV, 144MHz SSB Transceiver
    [ Hits: 2904 | Votes: 16 | Rating: 7.12 ]
  • The MGM Interface - General purpose RTX-PC sound card Interface for MGM (Machine Generated Modulation)
    [ Hits: 322 | Votes: 1 | Rating: 10.00 ]
  • The Old Radio Builder - This site is dedicated to those who enjoy building radios and other electronic devices using parts and techniques from bygone eras.
    [ Hits: 350 | Votes: 0 | Rating: 0.00 ]
  • The Repeater Builder's Technical Information - If you want to build a repeater, this is the right place to start. Includes construction projects and reviews of repeater hardware available in the market.
    [ Hits: 1666 | Votes: 1 | Rating: 8.00 ]
  • The Super Sixty transceiver - The 'Super-Sixty' a 5 MHz 60 meters band transmitter & receive converter
    [ Hits: 1136 | Votes: 0 | Rating: 0.00 ]
  • Thermal cooling fan controller - N1HFX thermal coolin fan controller project
    [ Hits: 317 | Votes: 2 | Rating: 10.00 ]
  • Tools and Links for RF Power Amplifier Builders - This document lists a few tools, documents and websites which are valuable in the design and construction of amateur RF power amplifiers. The list is small but it represents a good starting point for the amateur amplifier builder.
    [ Hits: 1125 | Votes: 0 | Rating: 0.00 ]
  • Toroid Winding - Winding Toroids can be a real hassle for those of use who are left-handed or not so dexterous as we once were.
    [ Hits: 3247 | Votes: 4 | Rating: 7.75 ]
  • Transofrmer tutorial - Roll Your Own Power-Transformers
    [ Hits: 2066 | Votes: 2 | Rating: 8.50 ]
  • Unsoldering old electronic components - how to easy and quickly unsolder and recover electronic components from old electronic board (SMD and not) by iz7ath Talino
    [ Hits: 2724 | Votes: 1 | Rating: 7.00 ]
  • Visual CW Tuning Indicator - The Visible CW Tuning Indicator flashes an LED when the signal is properly tuned by Bob Wolbert, K6XX
    [ Hits: 441 | Votes: 0 | Rating: 0.00 ]
  • VK5JST Aerial Analyser - This antenna anlyzer project was published in the May 2005 issue of the Australian magazine "Amateur Radio", and has been designed using parts which are very readily available
    [ Hits: 2683 | Votes: 7 | Rating: 7.15 ]
  • W8JI Technical pages  pop - Amplifier, vacuum tube, receiving beverage loop vertical and transmitting antenna system technical information radiation resistance, EH antenna, noise,receivers, and information on keyclicks.
    [ Hits: 21322 | Votes: 35 | Rating: 8.23 ]
  • Wavemeter for Two and 70cm - G8ACC article project for a 144 & 430 MHz wavemeter
    [ Hits: 456 | Votes: 1 | Rating: 10.00 ]
  • Wide Band FM Tranceiver - 70 and 23 cm wide band FM tranceiver
    [ Hits: 3323 | Votes: 4 | Rating: 4.50 ]
  • Winding coils - winding coils for construction project
    [ Hits: 582 | Votes: 1 | Rating: 4.00 ]
  • Winding Toroids - A Guide to safely wind toroidal cores by vu2fd
    [ Hits: 2148 | Votes: 1 | Rating: 10.00 ]
  • Winding Transformers - Rolling your own transformers and chokes
    [ Hits: 455 | Votes: 0 | Rating: 0.00 ]
  • WN2A Homebrew Heaven  updated  pop - Stuff for Homebrewer
    [ Hits: 39659 | Votes: 21 | Rating: 5.67 ]
  • WV7U.com - Hank's Amp Pages - WV7U's YC156 and 3CPX800 amplifier projects. Everything you wanted to know about using the YC156 or 3CPX800 in a ham radio linear amplifier. See pictures, schematics, test data, links, and more!
    [ Hits: 1614 | Votes: 2 | Rating: 9.50 ]
  • Yagi Element Mounting Considerations - One of the most important considerations when designing and building a Yagi antenna is the method used to attach the elements to a boom. This is true because the boom influences the electrical length of the elements. In this article JH Reisert explain with drawings techniques on mounting yagi antenna elements to a boom
    [ Hits: 4020 | Votes: 0 | Rating: 0.00 ]
  • Z Match for Higher Power - Single coil Z match witch handles the power of the linear amplifier
    [ Hits: 3018 | Votes: 13 | Rating: 7.93 ]
  • ZL1BPU Rotator Controller - A very simple controller circuit, with fairly smart performance! The ZL1BPU Rotator Controller has been designed as an add-on unit for the popular Kenpro KR-400 and Yaesu G-400 rotators. The controller consists of a small circuit board which fits inside the rotator control box (see picture).
    [ Hits: 2718 | Votes: 3 | Rating: 4.00 ]

New Links Last Search
SPE Electronics
A 500 Watt HF Dummy Load and Power ...
A Dual Band VHF/UHF J Pole
Stealthy / Covert Antennas
York Region Amateur Radio
VK5JST VHF AERIAL ANALYSER
Introduction to NBTV
Teledyne
3 Element Delta Loop For 144 MHz
LISATS
Repairing Rotators
Remote Antenna Switching
The Tube Thing
BuxComm
Eliminate problems caused by RFI
  • Search dxzone.com on Ham Radio Homebrew
  • Lookup Google Custom Search Engine for Ham Radio Homebrew
  • Search Ham Radio Homebrew with: Yahoo!, Teoma, Lycos , Bing
  • Technical Reference

    Search only in "Homebrew"

    About The DXZone

    The DXZone is the largest human created and maintained library of web sites dedicated to Amateur Radio, currently lists 20.000+ links organized into 600+ categories and subcategories. Ham Radio operators review new sites every day since 1998, for potential inclusion in the Directory, and to evaluate the best place to list them.

    Technical Reference : Homebrew


    Category Stats

    Daily Top 10

    Get our links, Everywhere!

    Follow us on Social Networks
    RSS Feeds The DXZone.com RSS feed

    Sign up for daily Newsletter

    Service provided by Google FeedBurner

    Free for your Site

    Add our gadgets to your site
    Daily Top 10 links

    Google Custom Search