final
36 links
Pages: 1 2 [next]
Antennas : 40M- W1ZY 40 meter moxon antenna
- W1ZY's 40 Meter MOXON is the product of 9 months of experimentation. The final array is reversible and constructed from No. 12 insulated wire fed through two RF current baluns
[ Hits: 3345 | Votes: 2 | Rating: 6 ]
- A dipole for 6 meters
- KJ4WLH homemade dipole for 50 Mhz
[ Hits: 1250 | Votes: 2 | Rating: 7 ]
- KB6NU End-fed Half-Wave for 20m
- KB6NU end-fed, half-wave antenna article and project
[ Hits: 621 | Votes: 0 | Rating: 0 ]
- CQ WW 160 Results
- Final Results of the CQ world wide 160 meter contest including past editions
[ Hits: 312 | Votes: 0 | Rating: 0 ]
- Ham Logs Online
- Put your Ham Logs online, compare contest scores, send and receive electronic QSL requests and more. The place to see if you finally worked them!
[ Hits: 2600 | Votes: 6 | Rating: 1.83 ]
- N7BYU Brigham Young University Amateur Radio Club
- Brigham Young University Amateur Radio Club (BYUARC) was founded in 1949 and has been headquartered in several places on BYU campus over the years, finally coming to its permanent location in the Wilkinson Student Center in the 1970s.
[ Hits: 177 | Votes: 0 | Rating: 0 ]
- SARL - Ham Licence Study Guide
- South African Radio League, Radio Amateur Examination Study Guide
[ Hits: 451 | Votes: 1 | Rating: 10 ]
- Joe Tracker Ham Radio eBay Auction Price Tracker
- Ham radio equipment eBay prices, adjusted for trends, filtered for accessories, leaving only condition and auction terms to affect the final price. Also direct links to auctions, searches and recommended sites for research, plus amateur radio station rigs, projects and antenna farm.
[ Hits: 1122 | Votes: 3 | Rating: 9.67 ]
- Magnecor
- Finally auto ignition noise suppressor wires that really work.
[ Hits: 713 | Votes: 4 | Rating: 7.75 ]
- Calibrating the MFJ-259B Antenna Analyzer
- This calibration procedure is the correct procedure for later MFJ-259B's. Disregard any other information. Since MFJ-259B software has been changed under the same model number, you may find some final performance test steps not valid. These steps will involve parameters that do not appear on the display.
[ Hits: 637 | Votes: 4 | Rating: 1.25 ]
- Some HF Transceivers to Consider
- So, you finally upgraded and are ready to jump into HF. Here are some HF transceivers you might look at.
[ Hits: 901 | Votes: 2 | Rating: 1 ]
- 2 m. Band VHF PA 5 Watts
- A VHF power amplifier made with two cheap RF transistors, 2N3924 as driver and a BFS22A for final stage, giving an unexpected output power of 7-8 watts maximum
[ Hits: 1984 | Votes: 1 | Rating: 10 ]
- Six Meter Final Amplifier
- K9EID 75W power amplifier for the six meters
[ Hits: 570 | Votes: 0 | Rating: 0 ]
- A homebrew UHF Dummy Load
- A homebrew dummy load is usually a combination of several parallel carbon resistors, in order to be able a final resistance of 50 Ohms.
[ Hits: 1645 | Votes: 2 | Rating: 5.5 ]
- Hombrewing an HF Transceiver
- This page will describe the construction of a multi band SSB transceiver with all its components Band Pass Filter, Oscillator/Modulator unit, RX/TX Mixer TX Amp I.F. Amplifier AGC VFO Driver amplifier Receive audio amplifier Final amplifier Low pass filter Digital display and VFO stabiliser
[ Hits: 4366 | Votes: 6 | Rating: 8.33 ]
- 5 Watt 40 Meters transmitter
- This circuit is unique in that it uses a power mosfet as a final rather than a conventional bipolar transistor.
[ Hits: 8446 | Votes: 7 | Rating: 5.29 ]
- 7 MHz SSB Transceiver
- Circuit diagram and discription of 7 MHz Ham Radio SSB Transceiver. Transceiver using two MC1496, 4.43 MHz Ladder filter, LM386, LM324 and IRF840 in final.
[ Hits: 19051 | Votes: 43 | Rating: 6.48 ]
- PETH-49 2A Power Supply
- A linear regulated power supply 2A, 20 V designed mainly to get used to soldering and have something usefull as final result.
[ Hits: 414 | Votes: 2 | Rating: 7.5 ]
- Raspberry Pi Packet BBS
- Log of a Raspberry Pi Packet Radio BBS setup from first idea to final installation
[ Hits: 545 | Votes: 4 | Rating: 5 ]
- N5EG VNA
- This article describes a low-cost vector network analyzer that operates from 200 kHz to 100 MHz, and connects to a personal computer using a USB 1.1 interface By Tom McDermott, N5EG, and Karl Ireland
[ Hits: 2115 | Votes: 0 | Rating: 0 ]
Pages: 1 2 [next]
Not satisfied ? Lookup Google Custom Search Engine for final
Search final with: Yahoo!, DuckDuckGo
, Bing
Search
Related Searches
You can try similar terms
Get our links, Everywhere!
Follow us on Social Networks
|
RSS Feeds |
Sign up for daily Newsletter
Service provided by Google FeedBurner
Free for your Site
Add our gadgets to your site
Daily Top 10 links