fishing

fishing

Pages: 1 2 [next]

• 2 element Yagi for 20 meter - This antenna was designed for the CQ WW CW 2009 at EA8URL. All elements are made out of fishing rods with an insulated copper cable fixed on the rods by cable ties. Both fishing rods and cable are UV resistant.
  [ Hits: 634 | Votes: 2 | Rating: 5 ]

• 40m & 80m portable wire antenna - G8ODE antenna project, where the 40m & Short 80m antenna was deployed as a sloping wire antenna using the 10M fibre glass fishing pole and a hook on the house's gutter-board
  [ Hits: 3621 | Votes: 6 | Rating: 2.17 ]
• Helically wound antenna for 40m - A helically wound vertical antenna experiment. 14 meter of wire wounded on a 8 meter fishing pole with 4 elevated radials
  [ Hits: 539 | Votes: 2 | Rating: 9 ]

• Delta Loop DX Antenna for 40 meters band - A monoband delta loop antenna for the 7 MHz. This vertically polarized DX Antenna is a full wavelength sngle side antenna and has a total length of 42.3 meters (137,1 inch) Can be easily setup with a flag pole or fishing pole as center top mast. For optimal performance lower side should be at 2 meter above the ground. This antenna offers a low radiation angle and 1 DB Gain.
  [ Hits: 433 | Votes: 3 | Rating: 6.33 ]

• A shortened 40 meter rotary dipole - The antenna build into this project is made from 2 fishing poles on a fiberglass pole in the center.
  [ Hits: 1215 | Votes: 4 | Rating: 4.75 ]

• Stealth Multiband Vertical  ^pop - A vertical antenna for 40 and 80 meters band, using a telescoping fiberglass fishing pole.
  [ Hits: 52695 | Votes: 17 | Rating: 5.59 ]
• A very efficient half size 40 meter Vertical Antenna - A vertical antenna project for the 7MHz made with some spare parts. Based on a broken 20 foot fishing pole, it is based on a good ground system made with radials and a capacitive hat done to increase the global radiation resistance of the antenna. A custom loading coil is also included in this project to perfectly tune the antenna to the CW portion of the 40 meters band.
  [ Hits: 736 | Votes: 4 | Rating: 8.5 ]

• J-Pole Antenna for 50 MHz - This J-Pole is mounted on a fishing rod. The radiator L1 is an isolated copper-wire with a length of 281,5 cm while the quarter-wave matching sector L2 is made with 450-Ohm-Wireman-cable
  [ Hits: 223 | Votes: 0 | Rating: 0 ]

• Top Loaded Vertical Antenna for 80 Meters Band - Top Loaded Vertical Antenna 3,5 MHz 80m and a 14 MHz Trap for the 20m band. The weight of this portable vertical antenna is less than 1 kg, including the ground network. The weight of the telescopic fiberglass fishing rod is another 1kg. The rod expands from 1.5 meters to 8 meters.
  [ Hits: 268 | Votes: 0 | Rating: 0 ]

• Single element Delta Loop Antenna - Building a simple delta loop is very easy. With two fishing rods and some other material you can find in your local hardware store, you can build an efficient single element delta loop antenna
  [ Hits: 285 | Votes: 3 | Rating: 4.33 ]

• The 5 Bands Wire-Beam - This wire-beam has one radiator-element, feeded with 450-Ohm-Wireman-twinlead and needs an antenna-tuner. For the bands 6m, 10m, 12m, 15m, 17m and 20m bended reflector-elements are used. The support is a cross of 4 fibreglass-fishing-rods
  [ Hits: 5647 | Votes: 2 | Rating: 7 ]
• 5 Band Telescopic Vertical Antenna - 5 Band 1/4 wave Telescopic Antenna. The 20m to 10m, antenna is simple and cheap to make, and has a performance that matches commercial antennas but at cost considerably lower. The design was purposely based on a telescoping fibre glass fishing rod as this allows it to be easily stowed away in the car.
  [ Hits: 3608 | Votes: 3 | Rating: 9.33 ]

• Coaxial half-wave antenna - A handy solution to have a half wave antenna for fieldwork on a 12m fishing rod.
  [ Hits: 682 | Votes: 1 | Rating: 2 ]

• SlimJim for 28 MHz - A 10 meters band Slim Jim antenna project, made with a 450 Ohm slotted ribbon cable and secured on a 8 m fishing pole, by Steve G0KYA
  [ Hits: 1827 | Votes: 18 | Rating: 5.87 ]

• IK-STIC 2 vertical multiband antenna - The IK-STIC 2 is a vertical, all band, antenna that is over 25 feet tall yet weighs under 5 pounds. Based on a telescopic pipe or a fiberglass fishing pole, using a tuner it can easily cover the amateur radio HF bands from 40 - 10 Meters
  [ Hits: 4845 | Votes: 6 | Rating: 5.17 ]
• A low cost fishing pole vertical antenna  ^pop - This antenna is based on a 10 Metre long fibreglass fishing pole
  [ Hits: 25679 | Votes: 52 | Rating: 7.19 ]
• Multiband HF Vertfical Antenna - A vertical antenna that can cover HF bands using an UN UN and a fishing pole, usage of tuner is requested.
  [ Hits: 1692 | Votes: 1 | Rating: 10 ]
• Fishing Rod Vertical - A homebrew fishing-rod vertical using a very nice design from EB5EKT. This antenna works 20, 30, and 40M bands by selecting the tap points using alligator clips
  [ Hits: 2646 | Votes: 4 | Rating: 7.25 ]

• AOFU Fiberglass Products - Manufacture Fibreglass Rods poles Tapered Fibreglass Rods apply flag poles, Tent poles, Golf flag poles, Sail Battens, Skifield barriers, Kite struts, Sports field markers, Fishing rods.
  [ Hits: 1393 | Votes: 2 | Rating: 1 ]

• Pneumatic Antenna Launcher Plan - This air-powered Tennis Ball launcher is designed to launch tennis balls over trees towing fishing line.
  [ Hits: 429 | Votes: 1 | Rating: 10 ]

Pages: 1 2 [next]