hf loop

hf loop

Pages: [prev] 1 2 3 4

• VHF Bi-Square Beam Antenna - 2 Wavelength ,2 Meter Bi-Square Beam , 5dbd gain. This antennas are very cheeap to build and their radiation pattern is similar to a figure 8 with maximum signal through the loop but they may be used as a near-omnidirectional antenna
  [ Hits: 188 | Votes: 2 | Rating: 9 ]

• 70Mhz (4 metre) Delta Loop Antenna - Discover the success story of creating a 4-meter Delta Loop antenna, ideal for improving radio communication. This horizontally polarized antenna offers efficient performance when mounted at VHF heights, catering to both HF and VHF characteristics. A simple, DIY project suitable for portable setups, providing versatile options for radio enthusiasts.
  [ Hits: 53 | Votes: 1 | Rating: 4 ]

• BalUn for Delta-loop & Quad-loop antennas - This Guide helps you to build the 1:2 BalUn 600 Watts DIY kit step by step. If a delta-loop or quad-loop antenna is powered with a coax cable from the transceiver it is necessary to use a 1:2 BalUn. This 1:2 BalUn uses a symmetrical 1:2 impedance transformer.
  [ Hits: 286 | Votes: 1 | Rating: 9 ]

• Beverage Transformers for HF Receiving Antennas  ^new - This FAQ covers building and buying transformers for loop-on-ground and Beverage antennas. Building one uses ferrite cores and thin wire. Buying is an option, with the DX Engineering BFS-1 being recommended. These transformers isolate the antenna from the cable to prevent unwanted signal pickup.
  [ Hits: 20 | Votes: 0 | Rating: 0 ]

• Halo Antenna for 50 MHz - The antenna described in this article is for 50 MHz, but the design can be scaled for any band, including VHF, UHF, or even the higher HF bands. The antenna is nothing more than a square loop of wire, approximately 30" (or ~76cm) per side. The loop is fed in the middle of one side, and the opposite side to the feed point has a gap in it.
  [ Hits: 299 | Votes: 0 | Rating: 0 ]

• RX Loop Antenna for 80 and 160 Meters - Four or Five turn one meter loop antenna for 80 and 160 meter band. This home made receive only antena can be assembled in a small place.
  [ Hits: 248 | Votes: 1 | Rating: 1 ]

• Magnetic Loop HF antenna - An homebrew HF Magnetic loop made with 2m length of 6mm diameter copper pipe formed into a near circle as the low loss inductor, a short length of coax as a capacitor,a short length of mains cable, again as a fixed tuned capacitor, a tunable 365pF air spaced capacitor, and a small Jackson C804 airspaced variable with a small 3-35pF trimmer in parallel
  [ Hits: 131 | Votes: 0 | Rating: 0 ]
• Magnetic Loop Antenna for 2 meters - A small, easy to build, copper tube magnetic loop antenna for the 2 meters band. In Italian
  [ Hits: 276 | Votes: 3 | Rating: 9.33 ]
• QRP HF Loop Antenna - This is an uncommon loop antenna, hombrewed without the small feeding loop. With small spare parts is possible to build a loop antenna tuner for portable usage tha can ben used with common HF QRP transceivers
  [ Hits: 162 | Votes: 1 | Rating: 10 ]
• 2 meter Magnetic Loop Antenna - VHF Antenna in a Lunchbox, The Magnetic Loop on Two Metres. The two metre magnetic loop is a compact antenna which can easily be hung up under the eaves, the carport, or any other place where space is limited including indoors
  [ Hits: 523 | Votes: 1 | Rating: 1 ]
• MagLoop 10 - 24 MHz - Pictures of a magnetic loop antenna for hf bands that works from 10 MHz to 24 MHz
  [ Hits: 166 | Votes: 1 | Rating: 3 ]
• K1FM Mini Magnetic Loop - Original HF magnetic loop antenna designed by the author to work in conjunction with QRP transceivers like the FT-817 in portable operations. In this configuration the loop can operate from 30 to 10 meters. Using a two spires radiator of the same diameter it also covers 40 meters.
  [ Hits: 118 | Votes: 1 | Rating: 8 ]

• The Loop on Ground Antenna - An experimental antenna for HF reception. It consists of a single loop element mounted on the ground. It is stealthy, small, and quiet. EZ-NEC plots and on-air test results are included.
  [ Hits: 301 | Votes: 3 | Rating: 8 ]
• Small HF RX Loop - This is very common W7IUV Flag Antenna design is based on the PY3AGD antenna because it uses the antenna mounted horizontally and nd it is perfect for my small city lot installation.
  [ Hits: 147 | Votes: 0 | Rating: 0 ]
• RX Loop antenna - This loop antenna is intended to be connected as an antenna for receivers that do not have a built-in antenna such as an HF set or an old tube radio. This square barrel is wound on a wooden frame. It consists of two windings that are galvanically isolated from each other, a main and a coupling winding. The diameter is about 40 cm.
  [ Hits: 60 | Votes: 0 | Rating: 0 ]

• EggBeater Antenna for VHF UHF - This antenna was conceived mainly for high-speed digital transmission via satellite. The antenna is made of two full waves loops , mounted at right angles to each other. Then coupled together, 90 degrees out of phase over a horizontal circular reflector. With this configuration the antenna is omni directional and circularly polarized.
  [ Hits: 231 | Votes: 0 | Rating: 0 ]

• Double Quad Antenna for VHF UHF - The structure of this dual band VHF UHF antenna is very simple. It consists of two identical square loops, whose sides measure a quarter wave, connected together at the ends. A project by I5NZR
  [ Hits: 247 | Votes: 6 | Rating: 6.33 ]
• VHF UHF BiQuad - This is a vertically polarized Broadside and Collinear Array each Loop is a vertically polarized Broadside Array both the right and the left side of the Loop is a bent 1/2 wave dipole working 180 degrees out of phase with the other one and that gives you 4.15dbi of gain
  [ Hits: 176 | Votes: 0 | Rating: 0 ]

Pages: [prev] 1 2 3 4