raspberry pi 2
40 links
Pages: 1 2 [next]
Operating Modes : Satellites : Weather Satellite- Receiving GOES-16 Images with an RTL-SDR
- Receive GOES-16 and GOES-17 Images with a Raspberry Pi and RTL-SDR dongle
[ Hits: 188 | Votes: 0 | Rating: 0 ]
- Barest of bones APRS RF position reporter
- Super Simple APRS Position Reporter. This project idea has been in response to the more hardware heavy Raspberry Pi projects that involve extra TNC hardware, additional sound cards, and custom cabling. This APRS position reporter is done using a Raspberry Pi B+, USB GPS receiver, Baofeng UV-5R, and a mono 3.5mm audio cable between the Pi and HT.
[ Hits: 183 | Votes: 0 | Rating: 0 ]
- Arduino Beacon
- A new multi-mode QRP radio beacon built around the Arduino. The beacon started with the usual lash-up on the bench, hooking the previously reported Wotduino and DDS Shield up to a driver and a transmitter module, as previously used for the Raspberry Pi beacon
[ Hits: 707 | Votes: 0 | Rating: 0 ]
- WSPR beacon on Raspberry Pi
- Settng up a 40 meter WSPR beacon based on Raspberry Pi by VA3PAW
[ Hits: 952 | Votes: 3 | Rating: 10 ]
- Raspberry Pi as RTL2832 Remote Server
- Setting up a Raspberry Pi as Remote Server for RTL2832u SDR
[ Hits: 1526 | Votes: 6 | Rating: 7.17 ]
- D-RATS on Raspberry Pi
- Running D-Rats on a Raspberry Pi documentation and instruction by n0so
[ Hits: 758 | Votes: 1 | Rating: 5 ]
- WSPR transmitter using a Raspberry Pi
- Makes a very simple WSPR beacon from your RasberryPi by connecting GPIO port to Antanna (and LPF), operates on LF, MF, HF and VHF bands from 0 to 250 MHz.
[ Hits: 961 | Votes: 6 | Rating: 4.5 ]
- TNC-Pi
- TNC-Pi is a special version of TNC-X designed to interface directly with the Raspberry Pi computer. It can connect to the Pi either via the Pi serial port, or via the I2C protocol.
[ Hits: 848 | Votes: 2 | Rating: 10 ]
- Slow Scan TeleVision with Raspberry Pi
- Portable SSTV camera that takes a picture and transmit it with ham radio SSTV
[ Hits: 1062 | Votes: 1 | Rating: 6 ]
- SDR Server with Raspberry Pi
- Setting up a Raspberry Pi as a SDR Server with RTL-2832U USB dongle
[ Hits: 1990 | Votes: 4 | Rating: 6.25 ]
- Raspberry Pi WSPR beacon
- How to build a simple WSPR beacon using the Raspberry Pi for the transmitter
[ Hits: 1330 | Votes: 4 | Rating: 7 ]
- GNU Radio on Raspberry Pi 2
- Taking the Raspberry Pi 2 for a Test Drive with GNU Radio. Installing GNU Radio and receiving aircraft radar with a USB TV tuner
[ Hits: 723 | Votes: 0 | Rating: 0 ]
- Raspberry Pi and Sound Input
- Connecting and configurig an USB Sound Card key to the raspberry Pi to allow digital mode decoding and remote rig applications
[ Hits: 650 | Votes: 1 | Rating: 1 ]
- Raspberry Packet Radio BBS
- This page describes how to set up RaspBerry Pi Linux system with already configured AX.25 softwares on SD or micro SD cards
[ Hits: 683 | Votes: 1 | Rating: 8 ]
- Raspberry PI Presentation
- Introduction to Raspberry Pi and possible usages in amateur radio, PDF presentation.
[ Hits: 694 | Votes: 0 | Rating: 0 ]
- Radioberry by PA3GSB
- Radioberry Radio hat for raspberry pi.
HF (0-30 MHz) The latest development of PA3GSB is a radio card plugged into a raspberry pi (2 or 3) , a so called rpi-hat, forming an amateur radio.
[ Hits: 1248 | Votes: 4 | Rating: 9 ]
- Raspberry Pi - Packet Radio BBS setup howto
- This project describe how to setup a Raspberry Pi Linux system with a few AX.25 packet radio applications already installed on.
[ Hits: 691 | Votes: 3 | Rating: 9.33 ]
- Raspberry Pi - TNC-Pi
- Configure a TNC-Pi for a Raspberry Pi.
The TNC-PI can be used with applications that use the Linux ax.25 stack, or applications that expect to see a KISS TNC on a serial port.
[ Hits: 243 | Votes: 1 | Rating: 8 ]
- A Simple Raspberry APRS Position Reporter
- Barest of bones APRS RF position reporter using a Raspberry Pi B+, USB GPS receiver, Baofeng UV-5R, and a mono 3.5mm audio cable between the Pi and the radio
[ Hits: 329 | Votes: 0 | Rating: 0 ]
- Guide to decode SSTV with RaspberryPi and RTL-SDR
- A tutorial on how to setup a receiver capable to decode SSTV signals with a small RaspberryPi version 2 and a RTL-SDR dongle. The author explains how to install the needed software to interface the RTL-SDR and a step by step guide to install the QSSTV software used to decode the signals.
[ Hits: 333 | Votes: 1 | Rating: 1 ]
Pages: 1 2 [next]
Not satisfied ? Lookup Google Custom Search Engine for raspberry pi 2
Search raspberry pi 2 with: Yahoo!, DuckDuckGo
, Bing
Search
Related Searches
You can try similar terms
raspberry raspberry pi raspberry pi 3 raspberry pi sdr raspberry rpi raspberry rtl-sdr sdr raspberry pi aprs raspberry ham radio raspberry pi raspberry aprs raspberry pi and ham radio raspberry pi ham radio raspberry pi repeater raspberry pi wspr raspberry pi repeater controller
Get our links, Everywhere!
Follow us on Social Networks
|
RSS Feeds |
Sign up for daily Newsletter
Service provided by Google FeedBurner
Free for your Site
Add our gadgets to your site
Daily Top 10 links