50 watt amp
19 links
Radio Equipment : HF Transceivers : Elecraft K3
- ZL2IFB Elecraft K2 K3
- A page dedicated to the Elecraft K2 and K3 transceivers, Connecting the K3 to your PC
Useful K3 features, K3 REF CAL re-calibration of the VFO frequency, W2 wattmeter, KPA500 QSK amplifier
[ Hits: 104 | Votes: 2 | Rating: 10 ]
- 600 Watt HF Amplifier
pop
- Schematics plans by K9GDT and all infos to build a 600 Watt HF Amplifier.
The amplifier uses four Motorola MRF150 50 volt TMOS power FETs configured in push-pull/parallel and biased for class AB linear operation.
[ Hits: 70395 | Votes: 127 | Rating: 4.45 ]
- 10 W Linear Amplifier
- This article describes a 10 watt linear amplifier that is capable of delivering over 15 watts into 50 ohms and uses cheap plastic transistors that are used in CB equipment. by Harry Lythall - SM0VPO
[ Hits: 11426 | Votes: 12 | Rating: 5.25 ]
- N1IBC Eimac 4CX1500B HF Power Amplifier
- 1500 Watt HF power amplifier
[ Hits: 5034 | Votes: 6 | Rating: 3.83 ]
- K0GKD Solid State amplifier
- High Power Solid State 600 Watts Output Motorola MRF 150 FETs
[ Hits: 4882 | Votes: 15 | Rating: 7.34 ]
- 500 WATT PA by SM0VPO
- 500W Power Amplifier by Harry Lythall - SM0VPO
[ Hits: 18886 | Votes: 19 | Rating: 5.62 ]
- 1500 Watt Solid State HF Amplifier
- This is a project to develop an Open Source reference design for a 1500 watt solid state linear amplifier for 10 through 160 meters by K6IF
[ Hits: 9879 | Votes: 18 | Rating: 3.38 ]
- GS-35B Tube Amp
- 160-10 Meters 1500 Watt Amp - W4NFR
[ Hits: 577 | Votes: 2 | Rating: 9.5 ]
- 3-500Z Amplifier Project
- This article loaded with nice pictures and schematics, describes a 160-10 meter linear amplifier that uses a pair of 3-500Z triode power tubes. It was designed and constructed by William Moneysmith, W4NFR.
The amplifier features fast warm up and 1500-Watt RF output with 100-Watts of drive.
[ Hits: 1082 | Votes: 4 | Rating: 9.5 ]
- A 600 Watt homebrew Solid State Amplifier
- A solid state linear based on EB104 Motorola Engineering Bulletin by Helge Granberg. It uses 4 MRF150 FETs in push-pull parallel to acheive 600 Watts from about 6 Watts drive
[ Hits: 1979 | Votes: 3 | Rating: 5.33 ]
- Dentron DTR-2000L restoration
- The Dentron DTR2000L is an HF amplifier from the 1980 era. It uses a single 8877/3CX1500A7 tube to produce about a kilowatt of RF output. In this page NR7N includes info on operation, restoration and mods.
[ Hits: 704 | Votes: 4 | Rating: 9.75 ]
- Stone Creek Special 600 HF RF Amplifier
- This is a Solid State Amplifier Project. It uses 4 MRF150 MosFet Power Transistors. The Power Supply Voltage is 50 VDC at 21.5 Amp. The max power available is 1,075 Watts. The Efficiency is about 65% +/- and runs Class AB Solid State.
[ Hits: 270 | Votes: 0 | Rating: 0 ]
- Homebrew 1 Watt 2.4 GHz Power Amplifier
- This will show you how to add a RF power amplifier to your Proxim Symphony for under $50. The cost is reduced by using the existing components on the Symphony, such as the PIN diode switch, and just inserting a higher power final amplifier.
Increase the RF output power of your wireless network card to 1 Watt.
[ Hits: 159 | Votes: 4 | Rating: 6.5 ]
- 50 MHz GS35B 1500 Watt Amplifier
- 50 MHz 1500 Watt Russian GS35B amplifier. Well documented. Complete construction details,pictures,schematics, and more.
[ Hits: 13686 | Votes: 32 | Rating: 6.82 ]
- 50 Mhz solid state 600W amplifier
- G3WZT John Matthews project of a 600 Watt solid state linear amplifier for the 6 meters band
[ Hits: 2178 | Votes: 0 | Rating: 0 ]
- 80W all mode VHF amplifier
- 80 watt multi-mode amplifier using one of the newer S-AV36 Toshiba modules. Less than 50 milliwatts will drive it to full output in any mode.
[ Hits: 530 | Votes: 0 | Rating: 0 ]
- TE Systems 6 Meter Amplifier Review
- TE Systems 0510G 50 MHz meter amplifier set up for 10 watts in and 170 watts out.
[ Hits: 157 | Votes: 2 | Rating: 5 ]
- U310 FET preamplifier
- Extremely reliable FET preamplifier can handle several watts directly into either the input or the output without failure
[ Hits: 1050 | Votes: 2 | Rating: 9 ]
- The Fox - 750 mw transmitter
- This RDF three transistor 144 MHz transmitter uses a 48 MHz scanner crystal as an oscillator / tripler. A second transistor boosts the signal to 40 milliwatts, a third amplifies the power output to 750 milliwatts.
Includes schematic and pictures.
[ Hits: 423 | Votes: 2 | Rating: 5.5 ]
Not satisfied ? Lookup Google Custom Search Engine for 50 watt amp
Search 50 watt amp with: Yahoo!, DuckDuckGo
, Bing
Search
Related Searches
You can try similar terms
200 watt 5 watt 1 watt amplifier 10 watt power amp 100 watt amplifier 200 watt amplifier 5 watt input 500 watt linear watt meter watt meters digital watt meter
Get our links, Everywhere!
Follow us on Social Networks
|
RSS Feeds |
Sign up for daily Newsletter
Service provided by Google FeedBurner
Free for your Site
Add our gadgets to your site
Daily Top 10 links