50 watt amplifier

50 watt amplifier

Radio Equipment : HF Transceivers : Elecraft K3

• ZL2IFB Elecraft K2 K3 - A page dedicated to the Elecraft K2 and K3 transceivers, Connecting the K3 to your PC Useful K3 features, K3 REF CAL re-calibration of the VFO frequency, W2 wattmeter, KPA500 QSK amplifier
  [ Hits: 104 | Votes: 2 | Rating: 10 ]

• 600 Watt HF Amplifier  ^pop - Schematics plans by K9GDT and all infos to build a 600 Watt HF Amplifier. The amplifier uses four Motorola MRF150 50 volt TMOS power FETs configured in push-pull/parallel and biased for class AB linear operation.
  [ Hits: 70396 | Votes: 127 | Rating: 4.45 ]
• 10 W Linear Amplifier - This article describes a 10 watt linear amplifier that is capable of delivering over 15 watts into 50 ohms and uses cheap plastic transistors that are used in CB equipment. by Harry Lythall - SM0VPO
  [ Hits: 11426 | Votes: 12 | Rating: 5.25 ]
• N1IBC Eimac 4CX1500B HF Power Amplifier - 1500 Watt HF power amplifier
  [ Hits: 5034 | Votes: 6 | Rating: 3.83 ]
• K0GKD Solid State amplifier - High Power Solid State 600 Watts Output Motorola MRF 150 FETs
  [ Hits: 4882 | Votes: 15 | Rating: 7.34 ]
• 500 WATT PA by SM0VPO - 500W Power Amplifier by Harry Lythall - SM0VPO
  [ Hits: 18887 | Votes: 19 | Rating: 5.62 ]
• 1500 Watt Solid State HF Amplifier - This is a project to develop an Open Source reference design for a 1500 watt solid state linear amplifier for 10 through 160 meters by K6IF
  [ Hits: 9880 | Votes: 18 | Rating: 3.38 ]
• 3-500Z Amplifier Project - This article loaded with nice pictures and schematics, describes a 160-10 meter linear amplifier that uses a pair of 3-500Z triode power tubes. It was designed and constructed by William Moneysmith, W4NFR. The amplifier features fast warm up and 1500-Watt RF output with 100-Watts of drive.
  [ Hits: 1082 | Votes: 4 | Rating: 9.5 ]
• A 600 Watt homebrew Solid State Amplifier - A solid state linear based on EB104 Motorola Engineering Bulletin by Helge Granberg. It uses 4 MRF150 FETs in push-pull parallel to acheive 600 Watts from about 6 Watts drive
  [ Hits: 1980 | Votes: 3 | Rating: 5.33 ]
• Dentron DTR-2000L restoration - The Dentron DTR2000L is an HF amplifier from the 1980 era. It uses a single 8877/3CX1500A7 tube to produce about a kilowatt of RF output. In this page NR7N includes info on operation, restoration and mods.
  [ Hits: 704 | Votes: 4 | Rating: 9.75 ]
• Stone Creek Special 600 HF RF Amplifier - This is a Solid State Amplifier Project. It uses 4 MRF150 MosFet Power Transistors. The Power Supply Voltage is 50 VDC at 21.5 Amp. The max power available is 1,075 Watts. The Efficiency is about 65% +/- and runs Class AB Solid State.
  [ Hits: 270 | Votes: 0 | Rating: 0 ]

• Homebrew 1 Watt 2.4 GHz Power Amplifier - This will show you how to add a RF power amplifier to your Proxim Symphony for under $50. The cost is reduced by using the existing components on the Symphony, such as the PIN diode switch, and just inserting a higher power final amplifier. Increase the RF output power of your wireless network card to 1 Watt.
  [ Hits: 159 | Votes: 4 | Rating: 6.5 ]

• 50 MHz GS35B 1500 Watt Amplifier  ^updated - 50 MHz 1500 Watt Russian GS35B amplifier. Well documented. Complete construction details,pictures,schematics, and more.
  [ Hits: 13686 | Votes: 33 | Rating: 6.92 ]
• 50 Mhz solid state 600W amplifier - G3WZT John Matthews project of a 600 Watt solid state linear amplifier for the 6 meters band
  [ Hits: 2178 | Votes: 0 | Rating: 0 ]
• 80W all mode VHF amplifier - 80 watt multi-mode amplifier using one of the newer S-AV36 Toshiba modules. Less than 50 milliwatts will drive it to full output in any mode.
  [ Hits: 531 | Votes: 0 | Rating: 0 ]
• TE Systems 6 Meter Amplifier Review - TE Systems 0510G 50 MHz meter amplifier set up for 10 watts in and 170 watts out.
  [ Hits: 157 | Votes: 2 | Rating: 5 ]

• U310 FET preamplifier - Extremely reliable FET preamplifier can handle several watts directly into either the input or the output without failure
  [ Hits: 1050 | Votes: 2 | Rating: 9 ]