60 m antenna

60 m antenna

Pages: [prev] 1 2 3 4 5 6 7 8 9 10 11 12 13 [next]

• 160m Band Loaded Inverted L Antenna - This is a simple 160 meters antenna, a short loaded inverted L. The linear lenght is 20 meters, with the loading coil at 5 meters from the feedpoint.
  [ Hits: 320 | Votes: 1 | Rating: 7 ]
• 160m Spitfire Antenna - Spitfire Collinear Arrays for 160 meters band at UA2FW
  [ Hits: 241 | Votes: 2 | Rating: 9.5 ]
• Experiments with 160m antennas - Experimentin wire antennas on top band using several type of aerials. This includes a 40 to 160 meters EndFed Half Wave kite antennas and 160m/80m loaded vertical antenna.
  [ Hits: 177 | Votes: 0 | Rating: 0 ]
• 160m Short Vertical Loft Antenna - This is a very small vertical 160m antenna that fits in the loft of even my small house. It was built as a way of getting a signal out on 160m for local AM contacts, but the local noise level was far too high to allow it to be used at night for this purpose. However, on WSPR it did a pretty good job with WSPR spots from a very long way across Europe being received when running 2.5W out.
  [ Hits: 208 | Votes: 1 | Rating: 7 ]
• Transmitting Ferrite Loop for 80-160 - Article from 73 Amateur Radio Today about experimenting on ferrite loops transmitting loop antennas for 80 and 160 meters bands.
  [ Hits: 604 | Votes: 3 | Rating: 7 ]
• Top Band on a Vertical Yagi - 160 Meters on the 3-element 80 Meter Vertical Yagi antenna
  [ Hits: 155 | Votes: 0 | Rating: 0 ]
• A 160 Meter Antenna Hybrid Design - This antenna looks like an inverted L antenna, yet it is not, it could also be viewed as a 160m off-center fed dipole antenna, it looks more like an end-fed 1/4 wave 160 meter antenna.
  [ Hits: 176 | Votes: 0 | Rating: 0 ]

• Short DL6WU yagi for 23cm - 1260 MHz yagi antenna for ATV with a total Bandwidth (3 dB) 1240-1280 MHz and 10 dBd gain
  [ Hits: 138 | Votes: 1 | Rating: 4 ]

• An Antenna for 75 and 80 Meters Band - A trap antenna dipole covering two differen bands made reusing an old 160/80m inverted vee antenna.
  [ Hits: 319 | Votes: 0 | Rating: 0 ]

• BalUn for Delta-loop & Quad-loop antennas - This Guide helps you to build the 1:2 BalUn 600 Watts DIY kit step by step. If a delta-loop or quad-loop antenna is powered with a coax cable from the transceiver it is necessary to use a 1:2 BalUn. This 1:2 BalUn uses a symmetrical 1:2 impedance transformer.
  [ Hits: 286 | Votes: 1 | Rating: 9 ]

• Beverage Receive Antenna - The Beverage we use is a DX Engineering RPS-1 dual directional 360 foot 109,7 m, oriented due North/South, six feet 1,8 m off the ground. The antenna uses 450 ohm ladder line as the antenna, and 75 ohm RG-6u for the feedline. The antenna runs atop the fence between our property and 5 acres of pasture next door.
  [ Hits: 151 | Votes: 4 | Rating: 7.25 ]

• Transformers for low-bands antennas - Transformers can be used as part of a hybrid combiner or as phase inverters for an RX antenna array.
  [ Hits: 153 | Votes: 2 | Rating: 5.5 ]

• Loop magnetic antenna for 80-160 meters band - Jeri Ellsworthhas started a video series devoted to building a magnetic loop antenna for the 160- and 80-meter bands. The first video, included after the break, is an overview of the rationale behind a magnetic loop
  [ Hits: 175 | Votes: 0 | Rating: 0 ]

• Balcony Vertical HF Antenna - The simple balcony vertical HF antenna made with plastic fishing pole. Just along the pole I install copper wire in 7 meter length. Then was installed ATU. It was used home brew tuner. For each band was used one counterpoise in length 0.8 x lambda/4
  [ Hits: 238 | Votes: 0 | Rating: 0 ]

• T2FD Antenna - Terminated and twisted folded dipole - T2FD is a 600-900 ohms folded dipole, terminated with resistor. Feed impedance is coupled with 50/600 ohms voltage balun. It is a wide band antenna with rather low SWR over the full designed frequency range: antenna tuner is seldom needed.
  [ Hits: 487 | Votes: 0 | Rating: 0 ]

• IAT Interactive Antenna Table - IAT is an excel sheet table evaluate parameters of VHF UHF antennas edited by Vladimir UR5EAZ. The difference between this tool and the existing VE7BQH Antenna Table is the use of G / T and C / N instead of the G / Ta parameter. In this table, Vladimir applies the ITU recommendations to assess the noise properties of a radio receiving system and shows the advantage of the G / T concept over the G / Ta concept when choosing an antenna.
  [ Hits: 106 | Votes: 4 | Rating: 9.5 ]
• Dual Band Quarter Wave Droopy Antenna - Adapted from a similar project by NA4IT. Made with one quarter wave 2 meter radiating element pointing upward and it is surrounded by four 70 cm elements.
  [ Hits: 345 | Votes: 1 | Rating: 9 ]

• WebSDR in Andorra - Listen to online WebSDR located in Andorra Europe. Four receivers on 60m, 20m, 40m, and 80m, connected to a dipole antenna direction East/West
  [ Hits: 130 | Votes: 1 | Rating: 5 ]
• UR5WT WebSDR on 80m - This WEBSDR runs on Raspberry PI4-8G, Afedri-Net RX for 160m, RTL-SDR stick with homemade SBL1 mixer upconverter and fullsize 160m Delta loop antenna 4m up. Operated from Ukraine by UR5WT, US5WE and UX5DH,
  [ Hits: 154 | Votes: 1 | Rating: 9 ]

• HF9V Antenna Setup and mods - Installation and modification of the popular Butternut HF9V antenna with the optional 160 meter addon. Article includes a modification to improve the performance on the top band
  [ Hits: 196 | Votes: 2 | Rating: 10 ]

Pages: [prev] 1 2 3 4 5 6 7 8 9 10 11 12 13 [next]