digital audio signal pro

digital audio signal pro

Operating Modes : Digital Modes

• Digital Mode General Operating Tips - Start by getting your audio levels sorted out, Having your levels correct is critical to maximum effectiveness in both TX quality and also for being able to decode signals properly. Guide to Filters and other Rig Settings to optimize your output signal
  [ Hits: 183 | Votes: 1 | Rating: 9 ]

• Optimizing TX/RX Levels in WSJT-X - Exploring digital radio modes, the author rethinks how to adjust transmit and receive levels in WSJT-X. Despite effective communication using Yaesu's settings, a new procedure aims for better performance. For RX, set audio device levels to 100%, disable AGC, and adjust RF gain. For TX, enable "Remember power settings" and adjust power output to avoid ALC engagement. This method ensures reliable communication without signal degradation, enhancing dynamic range and minimizing noise.
  [ Hits: 49 | Votes: 0 | Rating: 0 ]

• MiniDSP - MiniDSP is a platform for digital audio signal processing applications. Manufacture low cost digital signal processor kits for the DIY/OEM market. Our flexible audio platforms are software controlled and easily upgradeable.
  [ Hits: 620 | Votes: 2 | Rating: 6 ]

• WD6CNF DSP Filter - Audio Digital Filter, two bandpass filters, three notch filters, two noise filters graphical setting of filter center frequency and bandwidth Drag vertical lines on top of signal, Microphone input, speaker output Mono, 5 kHz bandwidth
  [ Hits: 4902 | Votes: 2 | Rating: 10 ]

• Spectrum Analyzer Real-time FFT - Eight-channel Audio Spectrum Analyzer is a set of Real-Time Multi-Channel Gauges for investigation of data accepted from any ADC you will want or 16-, 24- and 32-bit ADC of sound card. WDM drivers support. FFT Spectrum Analysis, OscilloScope, Frequency counter, AC/DC voltmeter, Signal-to-Noise Ratio, Signal-to-Noise and Distortion, Spurious-Free Dynamic Range, Effective Number Of Bits, Total Harmonic Distortion, Inter-Modulation Distortion, Phase Shift. Special modes of dual-channel FFT spectral analysis: Separate channels spectra, Spectra of digital sum, difference, product of two signals, Spectrum of digital product of original signal and its fundamental, Spectrum of Real and Complex Transfer Function, Cross Spectrum. Standart weighing of spectra according IEC and CCIR. Oscilloscope modes (for dual-channel ADC) are: original signals, sum, difference, dependence of one channel on another, amplitude distribution of input signals.
  [ Hits: 11316 | Votes: 9 | Rating: 7.77 ]