end feed

The DXZone.com

end feed

39 links

Antennas : 10M
  • A double extended Zepp for 10 meters - How to make a Double Extended Zepp Antenna, almost a conventional halfwave dipole fed in the center with 300 or 450 ohm feed line by kh6jrm
    [ Hits: 1280 | Votes: 3 | Rating: 8.00 ]
Antennas : 6M : 6 meter Yagi Antennas
  • 2 element Yagi for 50 MHz - This 6 meter 2 element yagi antenna is simple, compact and effective antenna for 50 Mhz. The design antenna was optimized with AO for best match to 50 ohms, no matching network. A choke balun is recommended to decouple feedline currents.
    [ Hits: 156 | Votes: 0 | Rating: 0.00 ]
Antennas : Baluns
  • Baluns in antenna systems - Understanding Baluns. This article explores some simple antenna system configurations and the effect of key system components, connections and dimensions on feed line common mode current.
    [ Hits: 976 | Votes: 2 | Rating: 2.50 ]
Antennas : Baluns : 4 to 1 balun
  • 1:4 Current Balun - This project is intended to aid in tuning a balanced antenna or feedline that has a high impedance 100-600 ohms by N5ESE
    [ Hits: 3174 | Votes: 5 | Rating: 8.00 ]
Antennas : Bazooka
  • KC0KJF Doble Bazooka - The Double Bazooka Dipole is a very efficient single band antenna which is very quite,and does not require the use of a balun. This antenna consists of coax (RG58) with the shield split at the center and the feedline attached to the open ends.
    [ Hits: 743 | Votes: 1 | Rating: 4.00 ]
Antennas : End-Fed
  • End-fed Vertical and J-pole - Understanding Gain differences, j-pole and end-feed vertical antennas.
    [ Hits: 1364 | Votes: 1 | Rating: 1.00 ]
  • Resonant Feedline Dipole - Experiences with the end-fed dipole based on the concepts presented by J. Taylor in an article titled RFD-1 and RFD-2: Resonant Feed-Line Dipoles in QST. August 1991.
    [ Hits: 510 | Votes: 0 | Rating: 0.00 ]
Antennas : End-Fed : End Fed Half Wave Antenna
  • End Fed Half Wave Antenna Coupler - Centre fed half wave dipoles make great, simple and effective antennas for the HF bands. Sometimes however, the centre feed is not ideal. This great project will improve the overall antenna performance.
    [ Hits: 1181 | Votes: 1 | Rating: 10.00 ]
  • 20m Half-Wave End Fed - A Half wave antenna has a high impedance feed point. This can be matched using a 1/4 wave stub matching section and converts the 40m vertical into an L-shaped 20m J-Pole antenna. The 300 ohm feeder used for this purpose must be kept away from the ground.
    [ Hits: 1005 | Votes: 1 | Rating: 10.00 ]
Antennas : Indoor
  • 88' Zig Zag Double Extended Zepp - A Double Zepp indoor antenna based on Cebik's reccomendations and design. Can cover HF bands, fed with 450 ohm open wire feeder terminating in an automatic antenna tuner, can perform incredible results.
    [ Hits: 2440 | Votes: 7 | Rating: 6.71 ]
Antennas : J-Pole
  • The Copper J pole Antenna - The copper J-Pole antenna soldered in a couple of hours with an interesting method to setup the feeding point
    [ Hits: 371 | Votes: 2 | Rating: 5.00 ]
Antennas : VHF UHF
  • VHF Yagi from Old TV Antenna - 6m/2m/70cm Yagi Antenna Built from Old TV Antenna This turned out to be a great little antenna. It works the 6 meter, 2 meter and 70 centimeter bands. You can use one common feedpoint or two seperate feedpoints depending on how you would like to connect this antenna to your transceiver.
    [ Hits: 583 | Votes: 1 | Rating: 10.00 ]
Antennas : W3EDP
  • The W3EDP Antenna - A wire antenna feeded with an unsymmetrical feed and a 1:4 balun can be tuned from 6 to 80 meters band but can be noisier than a dipole and cause RF in the shack
    [ Hits: 407 | Votes: 0 | Rating: 0.00 ]
Antennas : WiFi
  • A Tincan feed for 2.45GHz - Construction details for a simple but effective antenna for 2.45Ghz wireless lan use.
    [ Hits: 415 | Votes: 3 | Rating: 7.67 ]
Antennas : Windom
  • End Connected Windom - This page describes a successful antenna designed during 2014. It covers 4 HF bands 40/20/15/10m. A developed version of the old Windom idea, where the feed point is off centre.
    [ Hits: 307 | Votes: 1 | Rating: 4.00 ]
DX Resources : DX Peditions Manufacturers : Antennas : HF
  • HyEnd Company - HyEnd is a dutch amateur radio antenna manufacturer. Makers of the popular HyEndFeed Antennas, produce Baluns, bandpass filters and selle Line isolators, coax cables and connectors.
    [ Hits: 58 | Votes: 0 | Rating: 0.00 ]
Software : Utilities
  • Ham Call Lookup - Windows Phone - Ham Call Lookup is an windows phone app that allows you to perform amateur radio callsign lookups via QRZ.COM. It also incorporates DX cluster feeds, DXCC information retrieval and Solar data all within one application on your Windows Phone. For callsign lookups, the application uses the QRZ.COM XML interface, please register at QRZ.COM for an account if you do not already have one. The application will happily work with a free QRZ.COM account although it is recommended to use a paid account, as a minimum the XML Logbook Data paid option, in order to access the full functionality of callsign lookups within the application.
    [ Hits: 93 | Votes: 0 | Rating: 0.00 ]
Technical Reference : SWR Meters
  • What Does Your SWR Cost You ? - Wondering whether to spend a fine day with the YL or with the antenna? This article may help you decide by W1GV
    [ Hits: 534 | Votes: 0 | Rating: 0.00 ]

Not satisfied ? Lookup Google Custom Search Engine for end feed


Search end feed with: Yahoo!, DuckDuckGo , Bing

Search

Related Searches

You can try similar terms
300 ohm feed feed line live scanner feed

Get our links, Everywhere!

Follow us on Social Networks
RSS Feeds The DXZone.com RSS feed

Sign up for daily Newsletter

Service provided by Google FeedBurner

Free for your Site

Add our gadgets to your site
Daily Top 10 links

Google Custom Search