high power amplifier

high power amplifier

Pages: [prev] 1 2

• RF-Power Amplifiers - RF Power develope, produce and sell high quality solid state RF power linear amplifiers for hams. High Quality Solid State RF Power Linear Amplifiers produced in Italy by Radiocontrolli
  [ Hits: 744 | Votes: 9 | Rating: 8 ]

• Kuhne Electronic - High quality microwaves components for professional and radioamateurs. Power Amplifiers, Low Noise Amplifiers, Es hail 2 Converter Transverter, Signal Sources, Passive Components and Accessoires
  [ Hits: 93 | Votes: 0 | Rating: 0 ]

• Alpha 8410 Plate voltage issue - High Plate Voltages Reported via Telemetry on Alpha 8410 power amplifier by AE9K
  [ Hits: 239 | Votes: 0 | Rating: 0 ]

• 600W LDMOS Power Amplifier - A comeplete home made 600W LDMOS RF power amplifier. Settings can be made on a 7-inch touch screen, and on this screen you can see a lot of useful information during operation, such as output power, temperature, SWR, and so on. The power amplifier includes 2 MRF300 LDMOS FETs and several built-in sensors. The amplifier also contains several types of protection functions like too high current, too high swr, too high temperature, etc.
  [ Hits: 776 | Votes: 1 | Rating: 10 ]
• 20 W HF Power Amplifier - A HF power amplifier with a push-pull of AFT09MS015N. The (small-signal) gain of the amplifier is around 26 dB in the lower HF band and goes down to about 24 dB on the higher end and still around 21 dB at 50 MHz. Its input matching is relatively good at the lower HF and degrades above 10 MHz.
  [ Hits: 143 | Votes: 0 | Rating: 0 ]

• How to Design an RF Power Amplifier - This video will provide a foundation for understanding how power amplifier circuits work. If you are new to High Frequency Power Amplifier Circuit Design, this is the place to start.
  [ Hits: 659 | Votes: 1 | Rating: 10 ]

• Homebrew 1 Watt 2.4 GHz Power Amplifier - This will show you how to add a RF power amplifier to your Proxim Symphony for under $50. The cost is reduced by using the existing components on the Symphony, such as the PIN diode switch, and just inserting a higher power final amplifier. Increase the RF output power of your wireless network card to 1 Watt.
  [ Hits: 151 | Votes: 3 | Rating: 5.33 ]

Pages: [prev] 1 2