project based on antenna

project based on antenna

Pages: 1 2 [next]

• 160 m broad banded coax inverted L antenna - Based on a W4TWW project and modified by KN4LF
  [ Hits: 4988 | Votes: 4 | Rating: 1.75 ]

• Tape Measure 2M Beam - A Tape Measure Beam Antenna for Radio Direction Finding based on WB2HOL design.
  [ Hits: 571 | Votes: 0 | Rating: 0 ]

• 80m Vertical Antenna with Folded CounterPoise - A very efficient 80 meter Counterpoise antenna designed to reduce ground losses from inadequate radial systems beneath inverted L antennas, a project by DM2GM and DM4IM based on the original K2AV antenna concept.
  [ Hits: 1090 | Votes: 2 | Rating: 7 ]

• 10 15 20m Open Sleeve Dipole - Based on a simple project based on a 2 elements Yagi for 20m band, and then becomed a triband yagi with a open-sleeve feed system
  [ Hits: 786 | Votes: 3 | Rating: 3 ]

• EH Antenna for 20 meters band - An EH Antenna for 14 MHz by EB3EMD based on an original project by F5SWN
  [ Hits: 743 | Votes: 2 | Rating: 1 ]

• A Quadruple Helix for AO-40 - A homebrew project of a quadruple helix antenna system based on G3RUH 16 turn helix antenna for 2.4 GHz.
  [ Hits: 8281 | Votes: 10 | Rating: 6.1 ]

• Indoor antenna de F6CYV  ^{updated  pop} - Indoor wire antenna project for 7 Mhz band, basically a bent dipole antenna, design based on a project by F6CYV
  [ Hits: 49756 | Votes: 60 | Rating: 6.94 ]

• Tri-Band J-Pole - This strange looking antenna is a combination of Coupled-Resonator principle by K9AY and a quarter stubs to achieve low angle radiation pattern. Designed with 4nec2 NEC based antenna modeler and optimizer for 145/220/440MHz bands
  [ Hits: 1922 | Votes: 5 | Rating: 9 ]

• Maria Maluca for 6 to 20 meters - A two elements beam antenna tunable from 6 to 20 meters, based on the Maria Maluca antenna project by DB9EX, in german
  [ Hits: 2578 | Votes: 1 | Rating: 10 ]

• 6M Moxon - 50 MHZ Moxon antenna based on the KG4JJH design with some slight modifications in the construction
  [ Hits: 1784 | Votes: 3 | Rating: 1 ]

• 2 element wire Yagi - Hammock 2 element wire Yagi antenna for 3 bands 20-15-10 based on VE7CA project
  [ Hits: 6570 | Votes: 2 | Rating: 4.5 ]

• G4AYM - Slim Jim Antenna - A Sim Jim Antenna based on 300 ohm ribbon cable.
  [ Hits: 788 | Votes: 0 | Rating: 0 ]

• Z-Match 100 and mini Z-Match - This is a one for all antenna tuner with wide range tuning on all the HF bands. The tuner is based on a G3WQW design. DIY project by PD7MAA
  [ Hits: 924 | Votes: 0 | Rating: 0 ]

• G7AQK QRSS Beacon - A QRSS beacon on 30 meter band project wind and solar powered based on a loop antenna.
  [ Hits: 407 | Votes: 0 | Rating: 0 ]

• Antenna Rotator Project - An Antenna Rotator Project. The rotor design is based on sandwiching the gears and gear supports between two 5/16 inch 6061 T-6 aluminum plates
  [ Hits: 3036 | Votes: 0 | Rating: 0 ]
• AVROT project - Rotator controller, azimuth & elevation control of rotators (automatic antenna turning) based on commands from computer. A project by Pavel VACHAL and OK1DX - KF9VM
  [ Hits: 1425 | Votes: 0 | Rating: 0 ]

• Arduino antenna tuner - This project describes an ARDUINO based automatic antenna tuner, for an end-fed half wave (EFHW) antenna, working on 20 & 40 meter bands
  [ Hits: 4908 | Votes: 9 | Rating: 6.04 ]
• Arduino MFJ tuner control - An Arduino uno based project to control an MFJ 998 antenna tuner via Icom CI-V interface by VE1ZAC
  [ Hits: 825 | Votes: 0 | Rating: 0 ]
• Arduino Rotator Controller - Aduino-based Amateur Radio Antenna Rotator Controller that can emulate the Yaesu GS-232A or GS-232B interface by K3NG
  [ Hits: 877 | Votes: 2 | Rating: 10 ]

• Serial/USB SWR Meter - A low-cost SWR meter project based on Arduino that works with AutoCap automatic antenna tuner for magnetic loop antennas
  [ Hits: 781 | Votes: 2 | Rating: 5.5 ]

Pages: 1 2 [next]