simple wire vertical

simple wire vertical

Antennas : 10M

• A Low Profile 10 Meter Antenna - A simple vertical whip antenna for 28 MHz with three radials made of 8 foot pieces of scrap wire and a 102 inch whip
  [ Hits: 469 | Votes: 2 | Rating: 9.5 ]

• Vertical Dipole Antenna for 14 MHz by G3PND - An home made vertical dipole antenna made with simple material. The antenna has a total length of aproximately 16 feet. In this article appeared on June QST 2019, the author explain how he reached the optimal confirugation changing and adjusting the lower part of the antenna, trimming and spacing correctly the copper wire. PDF File to downloas
  [ Hits: 1225 | Votes: 3 | Rating: 4 ]

• A Simple High-Performance Vertical Antenna - This article describes the details of the design, which can be easily scaled for just about any HF band. The antenna described in this article is for the 20 meters band.
  [ Hits: 666 | Votes: 3 | Rating: 9.67 ]

• 80M Vertical antenna with capacitance hat - Simple wire antenna cheap to make, using readily available materials, Low angle radiation, with rejection of high angle signals Wide bandwidth, with resonance at the 80M DX window (3.790-3.800 MHz); and Maximum height is 40 feet
  [ Hits: 25088 | Votes: 23 | Rating: 7.05 ]

• Vertical Dipole Array - A simple and awesome wire monoband antenna, very usefull for portable and dxpeditions usage, consist of two elements, a driver and the reflector. This endfed halfwave gives a very low take off angle and is very suited for chasing DX.
  [ Hits: 1256 | Votes: 2 | Rating: 6.5 ]

• A simple NonDirectional Antenna for 10 meter - This article is about a simple vertical end-fed-half-wave wire antenna for 10 meters that can be used in case of restricted space.
  [ Hits: 702 | Votes: 2 | Rating: 7 ]

• Constructing simple wire antennas - Simple wire antennas like dipoles and verticals are dead easy to make: here's how
  [ Hits: 2420 | Votes: 0 | Rating: 0 ]

• Simple Balcony Antenna - Antenna for limited space, made from 24AWG wire helically wrapped around the top element of a 3-element cane pole, is basically a fully-loaded vertical and performance are limited and should represent the last resort for extreme cases.
  [ Hits: 924 | Votes: 1 | Rating: 7 ]
• Balcony Vertical HF Antenna - The simple balcony vertical HF antenna made with plastic fishing pole. Just along the pole I install copper wire in 7 meter length. Then was installed ATU. It was used home brew tuner. For each band was used one counterpoise in length 0.8 x lambda/4
  [ Hits: 238 | Votes: 0 | Rating: 0 ]

• Antenna for deed restricted lots  ^pop - An effective 10-20m DX antenna for deed restricted lots. The article by K7ZB introduces a simple 10-20m DX antenna suitable for deed-restricted lots. The antenna, a 15' vertical design, facilitated contacts with over 200 countries worldwide. Its design employs a telescopic aluminum tube and radial wires for multi-band operation, requiring an external antenna tuner for optimal performance. The mounting scheme and construction details ensure effectiveness and ease of use.
  [ Hits: 56294 | Votes: 13 | Rating: 6.46 ]

• K4TR Antennas - K4TR Manufacture and sell simple dipoles, half square 2 wire phased vertical arrays, end fed zepp antennas, G5RV antennas. 1:1 baluns
  [ Hits: 4429 | Votes: 8 | Rating: 7.88 ]