A Lowband Antenna that is Almost Freepop
- The Shunt-fed Tower, an effective Low Band Antenna, uses your beam as a capacitive top-hat and only needs a simple feed network and a good ground system to work DX on 80M and 160M.
80M Vertical antenna with capacitance hatpop
- Simple wire antenna cheap to make, using readily available materials, Low angle radiation, with rejection of high angle signals Wide bandwidth, with resonance at the 80M DX window (3.790-3.800 MHz); and Maximum height is 40 feet
New HF antenna HB9ABXupdatedpop
- A new, revolutionary design allows the construction of small HF antennas,
which provide the same efficiency as large antennas. This antenna can be built for all HF bands, from 10 to 80 m.
Half square antenna
- The elevated half square antenna is a very simple antenna that can be constructed from common materials yet gives significant improvement over a dipole at the same elevation. Ground mounted versions of this antenna are commonly used in amateur radio for 75/80 and 160 meter bands
- FAX480 was developed to provide for relatively high resolution image transmission on HF, VHF, and UHF amateur radio bands. FAX480 was designed to bridge the gap between conventional slow scan television (SSTV) and conventional facsimile techniques.
A low power 3.5MHz ARDF transmitter
- This low power transmitter is developed for ARDF exercising purposes but of course can be used as super QRP transmitter either. With 1 or 2 meter wire as antenna and a ARDF receiver with ferrite-rod antenna the range is about 100m but with better antennas and a 'real' receiver the range is probably much larger.
- RigResident is a small program for RIG control, which does allow to set and read data of connected tranceiver (frequency, mode etc).
RigResident supports more than 70 TRX models from ICOM, KENWOOD, YAESU and Ten-Tec.
A 80/40m Direct Conversion HF Receiver with DDS VFO
- Juha (OH2NLT) and Matti (OH7SV) have designed JUMA-RX1, an award winning 80/40m direct conversion HF receiver with highly accurate direct digital synthesis VFO. The receiver is very compact, because it constructed using surface mount components. No coils need to be wound to construct this receiver!