arduino antenna switch

arduino antenna switch

Technical Reference : Antenna Switch

• Automatic Arduino Antenna Switch - A Programming-Free Automatic Arduino Antenna Switch project published on NCJ
  [ Hits: 452 | Votes: 0 | Rating: 0 ]
• Smart SO2R Antenna Switcher: A DIY Solution - In pursuit of enhanced station efficiency, the author describes crafting an Arduino-based smart antenna switcher for an SO2R setup. Faced with manual antenna switching challenges during contests, the project utilizes a Logos Electromechanical 4x4 Driver Shield and a Power Screw shield for seamless functionality. Despite its raw appearance, the automatic switcher proves indispensable in contest scenarios, prompting considerations for future improvements and standardization of station control protocols.
  [ Hits: 154 | Votes: 0 | Rating: 0 ]

• Arduino automated antenna switch - This Arduino project decode ICOM CAT frequency information and switch antennas according to preset values. RX and TX antennas can even be different, a project by ON7EQ
  [ Hits: 3013 | Votes: 4 | Rating: 9.75 ]
• Arduino Antenna Switch - A homemade remote antenna switch made with an Arduino Uno by KK7S
  [ Hits: 2313 | Votes: 0 | Rating: 0 ]
• Arduino remote antenna switch - CI-V based remote antenna switch project by IK5PWC
  [ Hits: 3211 | Votes: 8 | Rating: 8.28 ]
• Automatic antenna switch with Arduino Nano - Arduino Nano board based antenna coax antenna switch intended for use with ICOM CI-V protocol. When is used alone with transceiver without PC control (CAT software, any logging software with CAT functionality), the CI-V transceive option in TRX setup shall be set to ON.
  [ Hits: 141 | Votes: 1 | Rating: 9 ]
• IC-7300 Arduino Based Antenna Switch - An Arduino Based Antenna Switch For The IC-7300 that monitors the band voltage from the rear accessory socket on the IC-7300. Two RF antenna relays are used to switch to the appropriate output.
  [ Hits: 125 | Votes: 0 | Rating: 0 ]