2m power

2m power

DX Resources : Beacons : 10 meter beacons

• KG4WBH Beacon - 28.222mhz transmitting with 2 watts of power
  [ Hits: 271 | Votes: 0 | Rating: 0 ]

• GB3JB 2m Repeater - Willoughby Hedge - The Green Repeater Powered by Wind and Solar Energy
  [ Hits: 242 | Votes: 0 | Rating: 0 ]

• Discovery Power Amplifiers - The Discovery series of amplifiers are designed and built in the UK by Linear Amp UK Ltd, one of the world's leading amplifier manufacturers, specializing in high power RF tube amplifiers. The amplifiers use large GS31 or GS35 ceramic triode tubes. Band coverage 6m, 2m and 70 cms
  [ Hits: 3027 | Votes: 2 | Rating: 4 ]

• A 2.3GHz to 432MHz receiver converter - Receiver converter that can be plugged to the backside of the Yaesu FT-817 battery powered portable transceiver
  [ Hits: 1495 | Votes: 3 | Rating: 4 ]
• 2.3GHz to 432MHz RX converter for FT-817 - A very small receiver converter that can be plugged to the backside of the battery powered portable transceiver FT817 from Yaesu. A high performance receiver for 2.3GHz amateur radio signal
  [ Hits: 221 | Votes: 3 | Rating: 1.67 ]

• TE Systems 1452G Reviews - eHam reviews of the TE Systems 1452G 2m mobile power amplifier
  [ Hits: 204 | Votes: 0 | Rating: 0 ]

• Icom america - IC-V8000 page - IC-V8000 2M Mobile, power when you need it
  [ Hits: 1242 | Votes: 0 | Rating: 0 ]

• 2m W6PO Power Amplifier Project - A 3CX1500/A7 8877 144mhz W6PO amplifier, that running a little over 4kv on the plate, this Amp will do over 2kw out.
  [ Hits: 326 | Votes: 0 | Rating: 0 ]
• DL4MEA 144MHz and 432MHz Amplifier - 144 and 432 Mhz GS35b High Power Amplifier
  [ Hits: 3109 | Votes: 6 | Rating: 9.17 ]
• RW3AZ VHF amplifiers page - 2m/70cm GS31B Power amplifier pictures
  [ Hits: 1298 | Votes: 4 | Rating: 7.75 ]
• A 20W Amplifier for 2 meters - VU2RAR basic VHF power amplifier suitable for 144-146 Mhz output power can vary from 3 to 25 Watts.
  [ Hits: 3023 | Votes: 5 | Rating: 6.6 ]
• Power amplifier for 2m rig - An RF power supply for 144 MHz schematics and instructions
  [ Hits: 2208 | Votes: 2 | Rating: 4 ]
• VHF 1Kw Amplifier - 2 x GI7B in push-pull 2m and 6m 1kW Power amplifier from PA0ZH
  [ Hits: 1282 | Votes: 1 | Rating: 7 ]

• Power netfilter - Homebrew a Power netfilter
  [ Hits: 337 | Votes: 0 | Rating: 0 ]

• An universal power supply for rigs - VU3NSH article on high current universal supply for rigs
  [ Hits: 2000 | Votes: 0 | Rating: 0 ]

• 2M Programmable Fox-Or Transmitter - The 2 metre fox-or transmitter is a small low power transmitter which mounts in a small plasic pipe and runs off two AA batteries. The board measures just 12mm by 70mm.
  [ Hits: 1062 | Votes: 2 | Rating: 1 ]

• Cross Band Repeaters - Crossband Repeating is a process where a Ham transmits one signal on one band (typically UHF), and it is received by another radio with a better antenna/power installation, and re-transmitted (typically on VHF) to another radio system, or a repeater. Everyday examples of cross-band repeaters are repeater receive sites that hear the input signals on 2m and retransmit those signals on a frequency higher than 220 MHz.
  [ Hits: 204 | Votes: 0 | Rating: 0 ]