Search results

A home made J-Pole antenna for 50 MHz. This article describes how to build a J-Pole antenna for the 6-meter amateur radio band. It's a good choice for those who want an antenna with better performance than a simple wire dipole, but at a lower cost than buying a commercial antenna. The project requires soldering copper pipes and some specific materials, but can be built in a day

This article describes a simple but effective wide bandwidth six metre antenna

Pictures of a multiband dipole, build with simple PVC T and standard electrical wire

Here is a very simple 70cms dipole from Harald PD2HFE, which uses a single piece of RG-213 coaxial cable 34 cms in length.

It is very simple to build and you can tune it in your shack room

The best antenna is the simple Dipole. If you have height, you even can put up a quarter wave vertical or an inverted, but sometimes you may need shorten version by 4S7NR

This project started as a result of renewed interest in 40 meters coupled with the desire for an antenna system that would be more effective than the simple dipole.

A simple dipole built for two-band operation can be used for portable use and operate 20 and 40 meter bands

Described here is a simple omni-directional, vertically-polarized dipole for two meters. Made from coaxial cable, it can be rolled up and stored in a small container

This article describes a simple, inexpensive, dipole antenna that will rival the performance of a ten-meter beam.

Calculate your dipole, 3 element yagi and a simple dipole

The K4VX linear-loaded dipole for 7 MHz, simple and practical way to make a short but efficient 40-meter dipole.

NC4JB Josh explain in this article how to setup a simple and cheap indoor dipole antenna that can be used on almost all HF bands

K4TR Manufacture and sell simple dipoles, half square 2 wire phased vertical arrays, end fed zepp antennas, G5RV antennas. 1:1 baluns

A Center-Fed Half-Wave Dipole is probably the simplest of antennas to construct and use. It is usually suspended between two supports, from it's end insulators, and has the feedline hanging from the center.

It is very easy to create a simple 1/2 wave dipole, all you need is some lengths of wire such as the core of some mains flex or even a straightened out metal coat hanger, some co-ax cable and a connector for your scanners antenna input

A rotatable hanging loop antenna that has been specifically designed for hanging in a tree. Horizontally polarized with a broad azimuth pattern and gain of nearly 3dB over a simple horizontal dipole!

How to create a simple but effective half wave dipole, illustrated instrucions on how to build wire antennas

A 40 ft vertical dipole antenna that can cover HF Bands from 80 to 10 meters winding a dipole in a 12m HD telescoping fiberglass pole

Simple DIY stealth apartment antenna for 20m and 40m. It is basically a ZigZag quarter wave dipole antenna

The page describes the construction of a simple omnidirectional, vertically-polarised dipole antenna for two metres using coaxial cable. It can be used indoors or outdoors, with no extravagant gain claims. The project is low-cost and can be completed in about 20 minutes.

Here is a very simple and practical way to make a short but efficient 40-meter dipole. The K4VX Linear-Loaded Dipole for 7 MHz

A simple, cheap, efficient tv antenna that you can make yourself.

Put up the longest dipole you can fit, feed it with open wire line, connect it to the balanced output of your tuner and poof! Instant multiband antenna. Is life really that simple?

D3+ High Performance Antennas for Field Day. This article describes versatile broadband wire antennas. These antennas will double your effective radiated power over a dipole, will be easy and inexpensive to build and install, and will be simple to match.

The simple dipole is perhaps the best antenna for consistent performance. Basic page on dipoles by G3PTO

This article describes the design of an antenna for local contacts on 7MHz, including a simple and efficient matching system that presents a 50 ohm load to the transceiver.

The half wave dipole antenna is a simple and practical antenna model that consists of a half wavelength long centre fed conductor.

A simple beam antenna offering good performances on 3 bands by 9m2mso

A simple online folded dipole antenna calculator

A simple 7 bands off-center dipole wire antenna designed to work on 80 meters band and that can cover also 40m 30m 20m 15m 12m 10m with acceptable SWR

Add two parasitic elements to the sleeve dipole of a Netgear Router

A simple TRAP-dipole project for 20 and 40m bands includes EZNec simulations

This 4m Slim Jim Antenna is cheap and easy to build yet it greatly out performs the more usual dipole due to its low angle of radiation. An SWR of 1:1 is obtainable across the 4m ham radio FM band with a simple adjustment.

A simple center-fed dipole made just with a thin-wall PVC pipe, aluminum tape, and RG-8X coax

Centre fed half wave dipoles make great, simple and effective antennas for the HF bands. Sometimes however, the centre feed is not ideal. This great project will improve the overall antenna performance.

An home made vertical dipole antenna made with simple material. The antenna has a total length of aproximately 16 feet. In this article appeared on June QST 2019, the author explain how he reached the optimal confirugation changing and adjusting the lower part of the antenna, trimming and spacing correctly the copper wire. PDF File to downloas

A scanned PDF of this interesting book on HF Dipole antennas published by Stanford Research Institute

A simple coax dipole antenna for 144 MHz by 9A7PJT

A simple and awesome wire monoband antenna, very usefull for portable and dxpeditions usage, consist of two elements, a driver and the reflector. This endfed halfwave gives a very low take off angle and is very suited for chasing DX.

A dipole antenna for 7 MHz support for this antenna is fiberglass military mast

A simple to build full length 20/40 dipole antenna to be used in inverted vee configuration

A 2 meter dipole antenna by KV5R

Dipole, inverted V, full wave loop and grond plane antenna quick reference plans

An excel spreadsheet that in a really simple way checks how much to trim your antenna elements. Download the xls file and watch the presentation video include in this page

This simple antenna modelling windows software by F5IMV wil calculate a dipole,extended double Zepp,G5RV, ZS6BKW and many other wire antennas by F5IMV

An economical dipole for simple QRP HF homebrew rigs

An easy to build dipole for 21 and 14 MHz with traps made by two T50-6 toroids cores mounted on a simple PCB foil

A simple drawing schematic of a portable field dipole for 14 MHz with dimensions in meters and instruction for setting up the antenna and to store the radial for easy transportation

This article serves as a beginner-friendly guide to constructing a simple VHF dipole antenna for 2 meters, perfect for novices in the hobby. With an emphasis on affordability and simplicity, it explains the basics without overwhelming technical details. Recommendations for coaxial cable and mounting methods are provided, offering practical solutions for effective communication. By following these instructions, novices can build a functional antenna without breaking the bank.